BMW 7 Series: Special Tools
Brakes
DEVICE
Device MW
Note: (Bending device) For brake lines
Storage Location
A3
.png)
Fig. 1: Identifying Device (345100)
DEVICE
Device MW
NOTE: For turning back brake piston when fitting new brake pads, disc brakes front and rear.
.png)
Fig. 2: Identifying Device (341050)
GAUGE
Minimum set: Mechanical tools Gauge MW
Note: (Brake pad measuring gauge) For measuring brake pad thickness without dismantling wheels.
SI number
01 12 95 (992)
.png)
Fig. 3: Identifying Gauge (341260)
GAUGE
Gauge MW
Note: (Slide gauge) For measuring brake disk thickness.
.png)
Fig. 4: Identifying Gauge (341280)
HEXAGON SOCKET
Hexagon socket MW
Note: (Allen key) For removing and fitting the handbrake shoe mounting spring and the ABS impulse sensor
Storage Location
B10
.png)
Fig. 5: Identifying Hexagon Socket (344000)
READ NEXT:
Technical Data
FRONT BRAKE F01/F02/F07
FRONT BRAKE SPECIFICATION
REAR BRAKE
REAR BRAKE DISCS F01/F02/F07
REAR BRAKE DISCS SPECIFICATION
PARKING BRAKE F01, F02
PARKING BRAKE SPECIFICATION
Brakes - Tightening Tor
Cabin Air Filter
BMW - 750i &750Li
CABIN AIR FILTER
NOTE: Manufacturer's terminology for this filter is Microfilter.
REMOVAL & INSTALLATION
Overview of heater - A/C system components
Fig. 1: Overview Of Heate
SEE MORE:
Coolant
General information
Coolant consists of water and additives.
Not all commercially available additives are suitable
for the vehicle. Do not mix additives of different
colors. Observe the water - additive mixing
ratio of 50:50. Information about suitable additives
is available from a dealer's service
Safety At Work
1.1 Working with aluminium dust
Wear a fine dust mask.
E52 only: Use an explosion-proof extractor system (refer to Service
Information 5 01 00 532).
Note national regulations.
1.2 Removing sealant
Hydrochloric acid is created when PVC sealing material is heated to
temperatures in excess o
