BMW 7 Series (F01/F02) 2008-2015 Service Manual / General Electrical System / Windscreen Wipers
BMW 7 Series: Windscreen Wipers
- Checking Contact Angle Of Windscreen Wiper Arms On Front Windscreen
- Removing And Installing Or Replacing Console For Windscreen Washer System Complete With Motor
READ NEXT:
Checking Contact Angle Of Windscreen Wiper Arms On Front
Windscreen
Notes
NOTE: Precisely adjusting the contact angle of the wiper arms is crucial
to determining
wiping quality.
IMPORTANT: Wiper arms are only checked and not adjusted. ADJUSTMENT
DIMENSIONS
Remove wi
Removing And Installing Or Replacing Console For Windscreen
Washer System Complete With Motor
IMPORTANT: Read and comply with notes on protection against electrostatic
damage (ESD
PROTECTION).
IMPORTANT: Before installing the wiper arms, allow wiper motor to run into
rest position.
IMPORTANT
Headlight Washer System
ADJUSTING WASHER JETS FOR HEADLIGHT WASHER SYSTEM
NOTE: The washer jets of the headlight washer system have been adjusted
at the
factory and normally this setting is not altered (except by an acciden
SEE MORE:
Replacing Power Distribution Box (Luggage Compartment)
WARNING: Observe SAFETY INSTRUCTIONS for handling vehicle battery.
Necessary preliminary work
Clamp off BATTERY NEGATIVE LEAD
Disconnect both negative battery cables at F03
Remove FLAP IN LUGGAGE COMPARTMENT TRIM PANEL on right
If necessary, remove right WHEEL ARCH PANEL (at F01/F02/03)
Discon
Functions
Wiping
The wiper/washer system is switched on and off with the wiper switch. The
wiper switch is an integral part of
the steering column switch cluster SZL.
Wiper Switch
The wiper switch on the steering column stalk does not lock in position. It
always returns to its start position
after every ope
© 2019-2026 Copyright www.bmw7g11.com
