BMW 7 Series: Tire inflation pressure- Tire inflation pressures up to 100 mph/160 km/h
For speeds of up to 100 mph/160 km/h and for optimum driving comfort, note the pressure values in the tire inflation pressure table and adjust as necessary.
.gif)
These pressure values can also be found on the tire inflation pressure label on the driver's door pillar.
Do not exceed a speed of 100 mph/160 km/h.
Tire inflation pressure values up to 100 mph/160 km/h
740Li, 740Li xDrive, 750i xDrive, 750Li xDrive
.jpg)
.jpg)
M760Li xDrive
.jpg)
Tire inflation pressures at max.
speeds above 100 mph/160 km/h
Warning
In order to drive at maximum speeds in excess of 100 mph/160 km/h, please observe, and, if necessary, adjust tire pressures for speeds exceeding 100 mph/160 km/h from the relevant table on the following pages. Otherwise, tire damage and accidents could occur.
For speeds over 100 mph/160 km/h and for optimum driving comfort, note the pressure values in the tire inflation pressure table and adjust as necessary.
Tire inflation pressure values over 100 mph/160 km/h
740Li, 740Li xDrive, 750i xDrive, 750Li xDrive
Without high-speed tuning feature
.jpg)
.jpg)
With high-speed tuning feature
.jpg)
.jpg)
M760Li xDrive
Without high-speed tuning feature
.jpg)
.jpg)
With high-speed tuning feature
With M Driver's Package
READ NEXT:
Tire identification marks
Tire size
245/45 R 18 96 Y
245: nominal width in mm
45: aspect ratio in %
R: radial tire code
18: rim diameter in inches
96: load rating, not for ZR tires
Y: speed rating, before the R on ZR tires
Max
Tire tread
Summer tires
Do not drive with a tire tread of less than
0.12 in/3 mm, otherwise there is an increased
risk of hydroplaning.
Winter tires
Do not drive with a tire tread of less than
0.16 in/4 mm, as s
Changing wheels and tires
Mounting and wheel balancing
Have mounting and wheel balancing carried out
by a dealer's service center or another qualified
service center or repair shop.
Wheel and tire combination
General informati
SEE MORE:
Venting And Filling Cooling System With Vacuum Filling Unit
Notes
IMPORTANT: Lifetime coolant filling:
Never reuse used coolant!
When replacing and removing components which rely on the corrosion
protection effect of the coolant, it is essential to change the coolant. The
cooling system must therefore be drained and refilled.
In the case of other removal wo
Washer fluid
General information
All washer nozzles are supplied from one reservoir.
Use a mixture of tap water and windshield
washer concentrate. If desired, a windshield washer concentrate containing
antifreeze can be
used.
Recommended minimum fill quantity:
0.2 US gal/1 liter.
Safety information
Warning
So
