BMW 7 Series: Technical data
Vehicle features and options
This chapter describes all standard, country-specific and optional features offered with the series.
It also describes features and functions that are not necessarily available in your vehicle, e.g., due to the selected options or country versions. This also applies to safety-related functions and systems.
When using these functions and systems, the applicable laws and regulations must be observed.
General information
The technical data and specifications in the Owner's Manual are used as guidance values.
The vehicle-specific data can deviate from this, for instance due to the selected special equipment, country version or country-specific measurement method. Detailed values can be found in the approval documents, on labels on the vehicle or can be obtained from a dealer's service center or another qualified service center or repair shop.
Dimensions
The dimensions can vary depending on the model version, equipment or country-specific measurement method.
The specified heights do not take into account attached parts, for instance a roof antenna, roof racks or spoiler. The heights can deviate, for instance due to the selected special equipment, tires, load and chassis version.
.jpg)
.jpg)
Weights
.jpg)
.jpg)
Capacities
.jpg)
Observe further information on fuel quality
READ NEXT:
Appendix
General information
Any updates to the Owner's Manual of the vehicle
are listed here.
Updates made after the
editorial deadline
The following chapters were updated in the
printed version of the Owner'
BMW 7 Series (F01/F02) 2008-2015 Service Manual
Service manual for fifth generation BMW 7 Series (F01). This manual is designed to make life easier for drivers, not only for beginners, but also for experienced ones. You will become famil
SEE MORE:
LVDS Technology
The transmission of picture data from the CCC to the CID was performed by
means of an 8-wire LVDS (low
voltage differential signaling) line. With the introduction of the Car
Information Computer, the video signal is
now transmitted through a 2-wire LVDS line.
The change in picture data transmissi
Front collision mitigation- Switching on/off
Switching on automatically
The system is automatically active after every
driving off.
Switching on manually
Press the button.
The menu for the Intelligent Safety system
is displayed.
If all Intelligent Safety systems were switched off,
all systems are now switched on.
"Configure INDIVIDUAL": dep
