BMW 7 Series (F01/F02) 2008-2015 Service Manual / Engine / Supercharger With Control
BMW 7 Series: Supercharger With Control
- Connection Diagram, Vacuum Activation (N63)
- Removing And Installing/Renewing Heat Shield At Top (N63)
- Removing And Installing/Replacing Electric Changeover Valve On Exhaust Turbocharger, Left (N63)
- Removing And Installing/Replacing Exhaust Turbocharger, Right, Cylinders 1-4 (N63)
- Removing And Installing/Replacing Left Intake Plenum (N63)
READ NEXT:
Connection Diagram, Vacuum Activation (N63)
Fig. 462: Connection Diagram, Vacuum Activation (N63)
Connection (1) Black to exhaust flaps.
Distribute element (2), vacuum pump/vacuum reservoir (4).
Vacuum line (3) black to vacuum pump.
Vacuu
Removing And Installing/Renewing Heat Shield At Top (N63)
Necessary preliminary work
Remove both INTAKE FILTER HOUSINGS.
Remove both control sensors.
Release screws (1).
Lift out holder.
Fig. 468: Identifying Holder Screws
Release screw (2).
Tighteni
Removing And Installing/Replacing Electric Changeover Valve On
Exhaust Turbocharger, Left (N63)
Necessary preliminary work
Remove left TURBOCHARGER.
Release screws (1).
Remove electric changeover valve.
Installation note:
Replace O-ring.
Fig. 475: Identifying Electric Changeover Valve Scre
SEE MORE:
Replacing Control Unit For Left Xenon Headlight
WARNING: Version with xenon lighting system: Danger to life due to high
voltage!
Therefore disconnect all components from voltage supply before removal.
Work on the entire xenon lighting system (ignition unit, control unit and
lamp) may only be carried out by specialist personnel.
Comply with not
Starter With Mounting
REMOVING AND INSTALLING/REPLACING STARTER (N63)
Necessary preliminary work
Switch off ignition.
Disconnect BATTERY EARTH LEAD.
Remove right ENGINE SUPPORT ARM.
Release connector (1) and remove.
Slacken nut (2).
Tightening torque 12 42 2AZ.
Detach starter positive cable.
Fig. 60: Identifying
© 2019-2026 Copyright www.bmw7g11.com
