BMW 7 Series (F01/F02) 2008-2015 Service Manual / Steering And Wheel Alignment / Steering Wheel For Airbag
BMW 7 Series: Steering Wheel For Airbag
- Procedure After Airbag Triggering As Result Of An Accident
- Removing And Installing/Replacing Airbag Unit
- Safety Regulations For Handling Components With Gas Generators
READ NEXT:
Procedure After Airbag Triggering As Result Of An Accident
Check and/or replace following components after airbag triggering:
Satellites (control unit + sensor)
Components
Satellite, A-/B-pillar, left/right
Satellite, front door
Satellite, rear seat
Removing And Installing/Replacing Airbag Unit
WARNING: Observe the following instructions to avoid any risk of injury
by the
airbag unit.
Comply with SAFETY REGULATIONS for handling components with
gas generators.
Do not exert any force on t
Safety Regulations For Handling Components With Gas Generators
It is essential to comply with the regulations as specified in the law
relating to the use of explosives when
working on airbag units and seat belt tensioners.
Airbags, seat belt tensioners etc. are
SEE MORE:
Replacing Carriage For Rain Channel On Left And Right
Necessary preliminary tasks
Remove GLASS SLIDE/TILT SUNROOF LID
Remove RAIN CHANNEL
Lever out garage stop (1) with plastic wedge.
Fig. 32: Removing Garage Stop With Plastic Wedge
Advance carriage (1) up to opening and lift out.
Fig. 33: Lifting Carriage
REPLACING COMPLETE LOWER FRAME SECTION
N
Detaching Wheel Bearing Inner Ring From Drive Flange (Drive Flange
Removed)
Notes
IMPORTANT:
Special tool 33 4 409 must not be removed!
Insert special tool 33 4 408 into special tool 33 4 401.
Fig. 125: Positioning Special Tools (33 4 408), (33 4 401) And (33 4 409)
Position special tool 33 4 401 in conjunction with 33 4 408 on drive flange.
Fig. 126: Positioning Spec
© 2019-2026 Copyright www.bmw7g11.com
