BMW 7 Series: Service Information
Lane Departure Warning
The lane departure warning can be ordered has been available:
- Since 03/07 in the
- E60
- E61 and
- Since 09/07 in the
- E63
- E64
In the event of a replacement of components, the different features of the variants as described in the parts catalogue, and the instructions for the necessary coding and calibration routines stored in the diagnostics and programming system must be observed.
You will also find information on the lane departure warning in the "E60/E61 Lane departure warning" training Information.
High-beam Assistant
The high beam assistant was introduced for the first time in the E60, E61, E63 LCI, E64 LCI BMW models from 2007 Model Year.
The high-beam assistant is not available separately for the F01/F02 and is part of the ZDA Driver Assistance Package option.
Low-sensitivity Mode
A low-sensitivity mode has been implemented in order to comply with the US statutory requirements. In this mode, the sensors are less sensitive.
To activate this mode, the driver must press the turn signal stalk on the steering column forwards for 10 seconds with the vehicle stationary, the lights switched off and terminal 15 ON.
As soon as the high-beam assistant is activated, the driver receives a Check Control message indicating that low-sensitivity mode is active.
The high-beam assistant reverts to its basic state following a power cycle.
Check Control Indicator
The Check Control may display messages under the conditions described below.
CHECK CONTROL INDICATOR REFERENCE CHART
.png)
CHECK CONTROL MESSAGES REFERENCE CHART
.png)
.png)
READ NEXT:
Introduction
With the F01/F02, the customer is able to choose from a comprehensive range
of optional driver assistance
systems.
The individual systems and function units are becoming ever more densely
networked
System Components
Park Distance Control
The Park Distance Control of the F01/F02 is identifiable by the five
ultrasonic sensors on the front bumper. The
fifth sensor enables a high level of reliability in obstacle rec
SEE MORE:
Standby state
Concept
When standby state is switched on, most functions
can be used while the vehicle is stationary.
Desired settings can be adjusted.
General information
The vehicle is in the standby state after the front
doors are opened from the outside.
Display in the instrument cluster
OFF is displayed in t
Positioning Of Multitrailer Hood For Maintenance And Repair Work
IMPORTANT: At least two persons are needed to install and remove the hood
from the
platform.
Before installing and removing the hood, secure the BMW multitrailer and the
entire combination against rolling. For this purpose, use the parking brake and
the chocks of the BMW multitrailer.
The hood ca
