BMW 7 Series (F01/F02) 2008-2015 Service Manual / Driver Information Systems / Park Distance Control
BMW 7 Series: Park Distance Control
READ NEXT:
Introduction
With the F01/F02, the customer is able to choose from a comprehensive range
of optional driver assistance
systems.
The individual systems and function units are becoming ever more densely
networked
System Components
Park Distance Control
The Park Distance Control of the F01/F02 is identifiable by the five
ultrasonic sensors on the front bumper. The
fifth sensor enables a high level of reliability in obstacle rec
System Functions
Park Distance Control
PDC is activated in response to the engagement of reverse gear or the
operation of the PDC button next to the
gear selector switch.
Fig. 143: Identifying PDC And Rear View Came
SEE MORE:
Removing And Installing/Replacing Drive For Backrest Tilt Adjustment
(Comfort Seats In Rear Compartment)
Necessary preliminary tasks
Partially remove LEFT OR RIGHT BACKREST COVER
Installation
Powerlok screws must be replaced and must not be reused
Powerlok screws are mechanical screw locks with trilobular threads
Installation
Microencapsulated screws (Loctite) must be replaced and may not be
Checking Cooling System For Watertightness (N54, N63)
Notes
WARNING: Risk of scalding!
Only perform this repair work after engine has cooled down.
Protective measures/rules of conduct
Wear safety goggles
Wear protective gloves
Observe national/country-specific regulations
IMPORTANT: Risk of skidding due to coolant on the floor.
Danger of injury!
© 2019-2026 Copyright www.bmw7g11.com
