BMW 7 Series: Service and warranty
We recommend that you read this publication thoroughly. Your vehicle is covered by the following warranties:
- New Vehicle Limited Warranty.
- Rust Perforation Limited Warranty.
- Federal Emissions System Defect Warranty.
- Federal Emissions Performance Warranty.
- California Emission Control System Limited Warranty.
Detailed information about these warranties is listed in the Service and Warranty Information Booklet for US models or in the Warranty and Service Guide Booklet for Canadian models.
Your vehicle has been specifically adapted and designed to meet the particular operating conditions and homologation requirements in your country and continental region in order to deliver the full driving pleasure while the vehicle is operated under those conditions. If you wish to operate your vehicle in another country or region, you may be required to adapt your vehicle to meet different prevailing operating conditions and homologation requirements. You should also be aware of any applicable warranty limitations or exclusions for such country or region. In such case, please contact Customer Relations for further information.
Maintenance
Maintain the vehicle regularly to sustain the road safety, operational reliability and the New Vehicle Limited Warranty.
Specifications for maintenance measures:
- BMW Maintenance system.
- Service and Warranty Information Booklet for US models.
- Warranty and Service Guide Booklet for Canadian models.
If the vehicle is not maintained or is improperly maintained, this could result in serious damage to the vehicle. Such damage is not covered by the BMW New Vehicle Limited Warranty.
Refer to chapter engine oil change regarding recommended service intervals for oil changes.
READ NEXT:
General information
Electronic control devices are installed in the vehicle.
Electronic control units process data they
receive from vehicle sensors, self-generate or
exchange with each other. Some control units
are nec
Data entry and data transfer into
the vehicle
General information
Depending on the vehicle equipment, comfort
and individual settings can be stored in the vehicle
and modified or reset at any time.
For example, this includes:
Settings for the
SEE MORE:
Removing And Installing/Replacing Control Unit For Active Front
Steering
IMPORTANT: Read and comply with notes on PROTECTION AGAINST ELECTROSTATIC
DISCHARGE (ESD PROTECTION).
Necessary preliminary work
Disconnect BATTERY EARTH LEAD
RELEASE LEFT FRONT SEAT and tilt towards rear
Remove front left DOOR SILL COVER STRIP
Remove footwell SIDE TRIM PANEL on A-pillar
Remov
Replacing Engine Support/Front Left Side Frame Connection (Front
Left Wheel Arch Removed)
Observe procedure for REPAIR STAGE 3.
Read contents of BODY, GENERAL.
To remove engine support side frame connection
Following new body parts are required:
Connection, wheel arch/entrance
Fig. 121: Identifying Connection, Wheel Arch/Entrance
Open welded connections in areas (1).
Fig. 122: Iden
