BMW 7 Series (F01/F02) 2008-2015 Service Manual / Integrated Suspension Systems / Lamp Settings
BMW 7 Series: Lamp Settings
READ NEXT:
Adjust Non-Dazzle High-Beam Headlight
WARNING: Danger of injury!
Laser radiation at headlight adjustment aid.
Do not look into the beam!
NOTE: The high-beam headlight must be adjusted to prevent dazzle in the
following
cases:
After re
Adjusting Dynamic Light Spot Headlight
WARNING: Danger of injury!
Laser radiation at headlight adjustment aid.
Do not look into the beam!
NOTE: Dynamic Light Spot headlight must be adjusted in the following
cases:
After removing and in
Adjusting Fog Lights
Comply with TEST PRECONDITIONS FOR HEADLIGHT ADJUSTMENT.
Necessary preliminary tasks
Remove TRIM GRILLE IN BUMPER TRIM
IMPORTANT: Do not damage adjusting screw when adjusting fog lamp.
Adjust fog l
SEE MORE:
Repair Work On GFP Components With Gelcoat Surface
Scratches in Gelcoat surface
Scratches in the Gelcoat surface which do not allow the GFP mat structure to
show through can be touched up.
Sand out scratches with water and 800 wet sandpaper. Then sand with water and
2000 wet sandpaper. Prepare
repair area for polishing.
Cracks in Gelcoat surface
Replacing Center Mount Gaiter
Necessary preliminary work
Remove PROPELLER SHAFT.
NOTE: The propeller shaft is balanced.
The front and rear propeller shafts must be reassembled in the same position.
Detach gaiter (1) from groove (2).
Mark front propeller shaft (3) and rear propeller shaft (4) in one plane.
Fig. 25: Marking
© 2019-2026 Copyright www.bmw7g11.com
