BMW 7 Series: Introduction
The BMW Night Vision system provides the driver with a black-and-white image of the driving environment ahead of the vehicle in the central information display (CID).
BMW Night Vision is a 100% passive system without active infrared illumination. Objects situated ahead of the vehicle are shown in varying degrees of brightness depending on the temperature of these objects. This enables the driver to detect in good time heat-emitting objects such as people, animals, and other vehicles.
This thermal image is recorded with a Far Infrared camera (FIR) via a special imaging sensor which detects the infrared radiation in a specific wavelength range.
The BMW system is distinguished from infrared systems with active illumination by its resistance to dazzling, its long range, and its clearly structured image.
.png)
Fig. 1: Identifying CID Image
The system offers the following advantages:
- Improved vision in conditions of dusk and darkness
- No dazzling by the headlights of oncoming vehicles
- Highlighting of unilluminated, heat-emitting objects such as pedestrians, cyclists vehicles and deer, etc.
- Better overview of the driving situation thanks to the depiction of the route of the road beyond the headlight cone
- Enlarged depiction thanks to the zoom function of objects in the far distance at high speeds
- Illumination of bends/curves thanks to the bend/curve mode (pivoting of image detail)
- Illumination of dark courtyard and garage entrances
NOTE: The driving speed must be adapted to the relevant visibility conditions in each case. BMW Night Vision is designed as a supporting system, which, with a modified driving style, affords the driver an early, better overview of the road conditions ahead of the vehicle.
READ NEXT:
System Overview
IPO Diagram (E65/E66)
Fig. 2: IPO Diagram (E65/E66)
Connection of Control Units
Control Unit and Camera
The Night Vision control unit and the Night Vision camera are connected via
the following c
System Components
Components
The BMW Night Vision system consists of the following components:
Night Vision camera with camera bracket and camera washer jet
Night Vision control unit
Button in light switch center
Principles Of Operation
The BMW Night Vision camera is a thermal imaging camera, which converts
thermal radiation into electronic
signals and then into images visible to the human eye.
The thermal image is converted first
SEE MORE:
Replacing Left Control Sensor (N63)
Notes
WARNING: Risk of burning!
Only perform this work after engine has cooled down.
Necessary preliminary work
Check function of DME control unit
Switch off ignition
Remove AIR FILTER HOUSING
Unlock plug connection and detach.
Unclip control sensor cable at retaining clips.
Release control se
Removing And Installing/Renewing Pressure Lines For Valve Block
(Short)
Notes
WARNING: DANGER OF POISONING if oil is ingested/absorbed through the
skin!
RISK OF INJURY if oil comes into contact with eyes and skin!
IMPORTANT: Adhere to the utmost cleanliness. Do not allow any dirt to
enter the hydraulic system.
Do not draw off hydraulic fluid (risk of contamination).
