BMW 7 Series (F01/F02) 2008-2015 Service Manual / Instruments
BMW 7 Series: Instruments
Instruments - Special Tools
VADAPTER
Adapter MW
Note: (Adapter 15/20-pin) only for oil service - Replaced by 62 1 140, July 94
Storage Location
I 106
ADAPTER
Adapter MW
Note: For instrument panel
Storage Location
Y2
SI number
02 03 89 (038)
.png)
Fig. 1: Identifying Adapter (621300)
Instruments - Tightening Torques
HEAD-UP DISPLAY
TIGHTENING TORQUE SPECIFICATION - HEAD-UP DISPLAY
.png)
READ NEXT:
Carrying Out Ride Height Adjustment
NOTE: Ride height adjustment must be carried out after the following work:
Removal/replacement of ride height sensor or its control rod (only
necessary for vehicles with air suspension or vehicles
SEE MORE:
Replacing Battery Positive Lead Between Starter, Alternator And
Battery Positive Terminal (N63)
Necessary preliminary tasks
Read out fault memory of DME control unit
Turn off ignition
Disconnect BATTERY NEGATIVE LEAD
Remove RIGHT INTERCOOLER
Remove RIGHT INTAKE MANIFOLD
Open cover.
Release screw (1).
Tightening torque 12 42 3AZ.
Remove battery positive lead (2) from battery positive t
Removing And Installing/Replacing Engine Oil Cooler (N54, N63)
Necessary preliminary tasks
Remove front right WHEEL ARCH TRIM.
WARNING: Danger of scalding!
Only perform this work after engine has cooled down.
IMPORTANT: Wear protective goggles and gloves.
IMPORTANT: Adhere to conditions of absolute cleanliness when working on
the engine oil
circuit.
When r
© 2019-2026 Copyright www.bmw7g11.com
