BMW 7 Series (G11/G12) 2015-2022 Owners Manual / Controls / Driving stability control systems
BMW 7 Series: Driving stability control systems
READ NEXT:
Antilock Braking System
ABS
Vehicle features and
options
This chapter describes all standard, country-specific
and optional features offered with the series.
It also describes features and functions that are
not necessarily ava
DTC Dynamic Traction
Control
Concept
DTC is a version of the DSC Dynamic Stability
Control where forward momentum is optimized.
The system ensures maximum headway on special
road conditions or loose road surfaces, for instance
u
Integral Active Steering
Concept
The Integral Active Steering increases the maneuverability
and makes a more direct steering
response possible.
General information
Integral Active Steering is a combination of variable
steerin
SEE MORE:
Removing And Installing/Renewing Both Solenoid Valves On Right
Side (N63)
IMPORTANT: Always check that the solenoid valves are clean during removal
and
installation.
Possible malfunctions if valves are contaminated:
Irregular operation
OBD incorrect entry
Poor exhaust gas values
Low engine performance
IMPORTANT: Risk of damage!
Do not clean solenoid valves with co
Reinforcement Plate With Stud Bolt (Bonded)
In the case of a partial replacement piece, a body component is cut at a
point described in the repair instructions.
A reinforcement plate is bonded in to ensure sufficient strength.
Reinforcement plates are available as new parts and must also be used (refer to
Electronic Parts Catalogue).
NOTE
© 2019-2026 Copyright www.bmw7g11.com
