BMW 7 Series (G11/G12) 2015-2022 Owners Manual / Mobility / Breakdown assistance
BMW 7 Series: Breakdown assistance
Vehicle features and options
This chapter describes all standard, country-specific and optional features offered with the series.
It also describes features and functions that are not necessarily available in your vehicle, e.g., due to the selected options or country versions. This also applies to safety-related functions and systems.
When using these functions and systems, the applicable laws and regulations must be observed.
Hazard warning flashers
.gif)
The button is located in the center console.
The red light in the button flashes when the hazard warning flashers are activated.
Warning triangle
.gif)
The warning triangle is located on the inside of the trunk lid.
Press on the release, arrow 1, and swivel the cover down, arrow 2.
READ NEXT:
First-aid kit
General information
Some of the articles have a limited service life.
Check the expiration dates of the contents regularly
and replace any expired items promptly.
Storage
The first-aid kit is locate
BMW Accident Assistance
Concept
BMW Group Accident Assistance can be contacted
if assistance is needed in the event of an
accident.
General information
If the vehicle sensors detect a minor to moderately
severe accident, whi
Jump-starting
General information
If the battery is discharged, the engine can be
started using the battery of another vehicle and
two jumper cables. Only use jumper cables with
fully insulated clamp handles.
Safet
SEE MORE:
Operation And Indication
In order for the driver to be able to activate and use the high-beam
assistant, the light switch must first be set to
Automatic or light switch position II.
In the F01/F02, the high-beam assistant has its own activation button in the
turn signal/high-beam stalk on the
steering column.
While the
Removing And Installing/Replacing Left Or Right Antiroll Bar
Link/Integral Link
NOTE: If the integral link is detached from the swinging arm, it is
necessary after
installation to carry out a chassis/wheel alignment check.
Necessary preliminary work
Remove REAR WHEEL.
Release nut (1) and remove screw.
Tightening torque 33 32 4AZ.
Release screw (2) and remove integral link
© 2019-2026 Copyright www.bmw7g11.com
