BMW 7 Series (F01/F02) 2008-2015 Service Manual / General Electrical System / Wiring Harness
BMW 7 Series: Wiring Harness
- Installing Repair Cable For Left Side View Camera
- Installing Repair Cable For Reversing Camera
- Notes On Handling Wiring Harnesses And Cables
READ NEXT:
Installing Repair Cable For Left Side View Camera
Read and comply with notes on HANDLING WIRING HARNESSES AND WIRING.
NOTE: Work is shown on the F01 by way of example. There may be differences
in detail
in the case of other vehicle types and equipme
Installing Repair Cable For Reversing Camera
Read and comply with notes on HANDLING WIRING HARNESSES AND WIRING.
NOTE: Work is shown on the F01 by way of example. There may be differences
in detail
in the case of other vehicle types and equipme
Notes On Handling Wiring Harnesses And Cables
The following applies in general
To avoid damage, observe the following instructions:
Avoid compressive and tensile loads
To ensure professional repairs, perform repair work only with
BMW-approve
SEE MORE:
Stamping Vehicle Identification Number (Needle Stamping Unit)
Read and comply with GENERAL INFORMATION.
The needle stamping system 360 - VRM - BMW is required to stamp the vehicle
identification number.
Order number: 81 43 2 155 736
Sourcing reference:
BMW Workshop Equipment Catalogue.
Fig. 243: Identifying Display, Mains Adapter, Needle Stamping Unit,
Front Sub-Frame
Lowering/Raising Front Axle Support (Universal Lifter)
Notes
IMPORTANT: Before lowering front axle support:
Observe SAFETY INFORMATION on raising the vehicle.
In order to avoid damage to vehicle hoist, perform weight compensation on
vehicle.
Load spring strut domes with sand bags.
WARNING: SECURE
© 2019-2026 Copyright www.bmw7g11.com
