BMW 7 Series (F01/F02) 2008-2015 Service Manual / Engine And Gearbox Suspension / Transmission Suspension, Manual Transmission
BMW 7 Series: Transmission Suspension, Manual Transmission
REPLACING CROSS-MEMBER FOR TRANSMISSION MOUNTING (N63)
Necessary preliminary work
- Remove rear UNDERBODY PROTECTION.
- Support transmission with lifter.
Release screws (1) and (2).
Remove transmission cross member.
Tightening torque 22 32 3/4AZ.
.png)
Fig. 9: Identifying Transmission Mounting Screws
REPLACING RUBBER MOUNT FOR TRANSMISSION MOUNTING (N63)
Necessary preliminary tasks
- Remove GEARBOX CROSS MEMBER.
Release screws (1).
Remove rubber mount.
Tightening torque 22 32 2AZ.
.png)
Fig. 10: Identifying Rubber Mount Screws
READ NEXT:
Transmission Suspension, Autom. Transmission
REPLACING CROSS-MEMBER FOR TRANSMISSION MOUNTING (N63)
Necessary preliminary work
Remove rear UNDERBODY PROTECTION.
Support transmission with lifter.
Release screws (1) and (2).
Remove transmissi
SEE MORE:
Carrying Over Hole Pattern
When replacing a body component, it is necessary to carry over the hole
pattern from the existing body to the
new component.
The following pictures are a schematic representation of carrying over the hole
pattern on the example of the
front wheel arch.
Necessary preliminary tasks
Adjust new part
System Components
Steering Systems
There are two lateral dynamics systems available on the F01/F02:
Servotronic
Integrated Active Steering
Servotronic Components
The proportional valve for electronic volumetric flow control (EVV valve) and
the Servotronic valve are
directly controlled by the ICM regardless of wh
© 2019-2026 Copyright www.bmw7g11.com
