BMW 7 Owners & Service Manuals
BMW 7 Series (F01/F02) 2008-2015 Service Manual / Engine And Gearbox Suspension / Transmission Suspension, Autom. Transmission

BMW 7 Series: Transmission Suspension, Autom. Transmission

REPLACING CROSS-MEMBER FOR TRANSMISSION MOUNTING (N63)

Necessary preliminary work

  • Remove rear UNDERBODY PROTECTION.
  • Support transmission with lifter.

Release screws (1) and (2).

Remove transmission cross member.

Tightening torque 22 32 3/4AZ.

Transmission Suspension, Autom. Transmission
Fig. 11: Identifying Transmission Mounting Screws

REPLACING RUBBER MOUNT FOR TRANSMISSION MOUNTING (N63)

Necessary preliminary tasks

  • Remove GEARBOX CROSS MEMBER.

Release screws (1).

Remove rubber mount.

Tightening torque 22 32 2AZ.

Transmission Suspension, Autom. Transmission
Fig. 12: Identifying Rubber Mount Screws

    READ NEXT:

     Engine Electrical System

     Troubleshooting

     Battery Replacement Information

    A vehicle battery is constructed for the installation location and the individual power requirements of the particular vehicle. These individual power requirements depend on the motorization and dif

    SEE MORE:

     Front Brakes

    CHECKING BRAKE DISCS Necessary preliminary tasks Remove WHEELS. Checking thickness difference: Measure thickness difference within brake surfaces at 8 point (spread over the circumference) with a micrometer gauge Compare measurement result with setpoint value. Fig. 14: Measuring Thickness

     Removing And Installing/Replacing Both Multifunction Steering Wheel Switches

    Necessary preliminary work: Remove AIRBAG UNIT Release screws (1) on left/right on back of steering wheel (2). Fig. 226: Identifying Steering Wheel Back With Screw NOTE: Both multifunction steering wheel switches (1) are connected to each other by the wiring harness (2). Feed wiring harness (2

    © 2019-2026 Copyright www.bmw7g11.com