BMW 7 Owners & Service Manuals

BMW 7 Series: Seats

1.0 SEAT LEATHER CARE

"Karneol" leather care cleans the leather upholstery of mild stains or dirt. It also provides conditioners to prevent drying out. Not suitable for suede.

BMW Part No. 81 22 9 400 901.

2.0 PREMIUM LEATHER CARE KIT

BMW Part No. 81 11 024 455.

SEATS

ADAPTER CABLE

Adapter cable MW

NOTE: (Adapter cable OC3) OC3 mat in conjunction with ISTA --> action only USA and Canada

Seats
Fig. 1: Identifying Adapter Cable (520000)

HOOK

Minimum set: Mechanical tools Hook MW

Note: (Release hook) For removing the head restraint guides

Storage Location

B47
A47

SI number

01 08 03 (988)

Seats
Fig. 2: Identifying Hook (520070)

PLIERS

Pliers MW

Note: For securing clamps on seat cover

Storage Location

A13

SI number

52 06 87 (808)

Seats
Fig. 3: Identifying Pliers (520050)

Seats - Tightening Torques

FRONT SEATS

TIGHTENING TORQUE SPECIFICATION - FRONT SEATS

Seats

REAR SEAT, ELECTRIC

TIGHTENING TORQUE SPECIFICATION - REAR SEAT, ELECTRIC

Seats

REAR SEAT, MANUAL

TIGHTENING TORQUE SPECIFICATION - REAR SEAT, MANUAL

Seats

Seats

    READ NEXT:

     Sunroof And Convertible Top

    1.0 CONVERTIBLE TOP MATERIAL Cleaning Kit consists of three fluids for periodic maintenance of the top's outer surface: Car Shampoo For cleaning the entire convertible top. Add 2 to 3 capfuls of s

     Slide/Tilt Roof

     Sunroof

    REPAIR INSTRUCTIONS FOR BONDED SEALS 1. General information on handling rubber seal profiles If seals reveal partly detached protective film on delivery, they must not be bonded. Store seals at 5

    SEE MORE:

     Side collision mitigation

    Concept The system helps to avoid imminent side collisions. General information Four radar sensors in the bumpers monitor the space next to the vehicle from a minimum speed of up to approx. 130 mph/210 km/h. The minimum speed is country-specific and is displayed in the menu for the intelligent Sa

     Removing And Installing/Replacing Left Intake Plenum (N63)

    Necessary preliminary work Remove left INJECTION PIPE. Remove THROTTLE VALVE. Release screws on intake plenum from above without fail before lowering front axle. Secure ENGINE in installation position. Lower front axle, releasing screws on engine mount first. Release power steering pump, i

    © 2019-2025 Copyright www.bmw7g11.com