BMW 7 Series (F01/F02) 2008-2015 Service Manual / Fuel Supply System / Fuel Pump With Drive And Line
BMW 7 Series: Fuel Pump With Drive And Line
- Check Fuel Pressure
- Checking Fuel Delivery Pressure (N20, N53, N54, N55, N63, N74)
- Notes Regarding The Fuel Pressure Test (Reference Pressure: Surrounding Area)
READ NEXT:
Check Fuel Pressure
Necessary preliminary work:
Connect BMW diagnosis system.
IMPORTANT: Lines are under pressure!
Wear protective goggles and gloves.
Fuel can emerge spontaneously at high velocity when the fuel line is
Checking Fuel Delivery Pressure (N20, N53, N54, N55, N63, N74)
Necessary preliminary work:
Connect BMW diagnosis system.
IMPORTANT: Lines are under pressure!
Wear protective goggles and gloves.
Fuel can emerge spontaneously at high velocity when the fuel line is
Notes Regarding The Fuel Pressure Test (Reference Pressure:
Surrounding Area)
The characteristic of this version with ambient pressure:
The connection for the vacuum hose of the fuel pressure regulator is located
between the throttle and the air
cleaner or on the air cleaner.
SEE MORE:
Removing And Installing/Replacing Front Centering Mount For
Propeller Shaft
Necessary preliminary work
Remove PROPELLER SHAFT.
Completely fill centering bore hole (1) with viscous grease.
Drive special tool 11 1 310 with a plastic hammer into centering bore hole.
The centering bearing (1) is forced out of the propeller shaft by the pressure
on the grease filling.
If
Replacing Complete Propeller Shaft Center Bearing
Necessary preliminary work
Remove PROPELLER SHAFT.
NOTE: The propeller shaft is balanced.
The front and rear propeller shafts must be reassembled in the same position.
Detach gaiter (1) from groove (2).
Mark front propeller shaft (3) and rear propeller shaft (4) in one plane.
Installation note
© 2019-2026 Copyright www.bmw7g11.com
