BMW 7 Series (F01/F02) 2008-2015 Service Manual / General Electrical System / Auxiliary Cable
BMW 7 Series: Auxiliary Cable
- General Information On Intelligent Battery Sensor (IBS)
- Replacing Battery Negative Lead
- Replacing Wiring Harness In Left Or Right Front Door
READ NEXT:
General Information On Intelligent Battery Sensor (IBS)
NOTE: Do not connect the charger to the 12 V charging socket.
The 12 V charging socket is supplied with voltage by the rear power
distribution box via relay. This relay drops
out after terminal 15 OF
Replacing Battery Negative Lead
WARNING: Observe (SAFETY) INFORMATION ON AGM BATTERY and follow
INSTRUCTIONS FOR DISCONNECTING AND CONNECTING BATTERY.
Read and comply with notes and instructions on INTELLIGENT BATTERY
SENSOR.
Neces
Replacing Wiring Harness In Left Or Right Front Door
IMPORTANT: Read and comply with notes on HANDLING WIRING HARNESSES and
cables.
Necessary preliminary work
Close front side window completely
Disconnect BATTERY CABLE
Remove SOUND INSULATION IN FR
SEE MORE:
Pedals
Pedal Mounting Block
Removing And Installing (Replacing) Complete Bearing Support For
Foot Pedal
IMPORTANT: After completion of work, carry out function check.
Necessary preliminary work
Remove BRAKE SERVO
Release screws (1).
Remove control units from holder (2). Plugs remain connected.
Fig. 1:
Body Equipment - Operating Fluids
1.0 ADHESIVES/SEALANTS FOR GLASS
Sikaflex 255 Adhesive is a single component polyurethane with a minimum
curing time of 4 hours at 72ºF/22º
C and 38% relative humidity.
The windshield or rear window must be installed within 10 minutes of applying
the adhesive or a skin will form
on the adhesive
© 2019-2026 Copyright www.bmw7g11.com
