BMW 7 Series (F01/F02) 2008-2015 Service Manual / Automatic Transmission / Shift Valves, Parking Lock
BMW 7 Series: Shift Valves, Parking Lock
READ NEXT:
Manual Emergency Release Of Transmission Lock
Manual emergency release of transmission lock from inside vehicle is not
possible with GA6HP/GA8HP gearboxes from
03/2010
From production date 04/2010 on, the transmission lock release cable is
n
Release Transmission Lock Electronically
For various tasks, it is necessary to unlock and lock the parking lock.
Before unlocking the parking lock, secure the vehicle against rolling away.
Emergency release is only possible if the engine
Torque Converter
REMOVING AND INSTALLING/REPLACING TORQUE CONVERTER (GA6HP26Z) (N63)
Notes
IMPORTANT: After completion of work, check TRANSMISSION OIL LEVEL.
Use only approved TRANSMISSION OIL.
Failure to comply wit
SEE MORE:
System Components
ICM Control Unit
Only the system components that are linked to the new architecture of the
dynamic driving systems in the
F01/F02 are described in this Product Information. In essence, this is the new
ICM control unit and the
periphery equipment directly connected to this control unit.
Three othe
Reinforcement Plate (Bonded)
In the case of a partial replacement piece, a body component is cut at a
point described in the repair instructions.
A reinforcement plate is bonded in to ensure sufficient strength.
Observe notes on REPAIR STAGE 2.
NOTE: The following graphics serve as general illustrations of
reinforcement plat
© 2019-2026 Copyright www.bmw7g11.com
